Version September 2018
EN
9
HÜRNER HST 300 Print 315 2.0 User’s Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Further Optional Accessories
•
PC software
for downloading and archiving data on
PC (for all common Windows operating systems)
•
Label tag printer
for printing an identifier label for
the new joint right after the welding operation
•
USB stick
for data transfer from the welding unit on
the worksite to the printer or PC in your office (see
details at the end of this booklet)
5
Check-out and Operation
• To operate the welding unit, be sure that it is set on a
proper, level surface.
• Be sure that power supply/generator protection is 16 A
(slow blow).
• Plug the power supply cord into the mains power
supply or the generator.
• Read and comply with the User’s Manual of the gen
-
erator, if applicable.
5.1 Turning the Welding Unit on
After connecting the power supply cable to mains power
or a generator, turn the welding unit on using the On/Off
switch. This causes Display 1 to show.
Then the screen changes to Display 2.
Caution
CAUTION in case of System Errors!
If during the auto-test that the unit performs at
start-up, an error is detected, a “System Error” mes-
sage shows on the display. When this happens, the
welding unit has to be disconnected immediately
from the power suppy and the fitting, and it has
to be shipped to the manufacturer for repair.
5.2 Entering the Welder ID Code
The welding unit can be configured to ask for the welder
identification code before the fitting code is entered. The
display screen then shows the appropriate message. (Later
this screen can be accessed by a quick access routine; see
Sect. 6.1.) The numeric code can be entered either by read-
ing it from a tag with the scanner or by pressing the
ï
,
ð
,
ñ
,
ò
cursor keys. Whether the welder identification code
has to be entered and if so, when or how often, is deter-
mined in the “Settings” sub-menu of the configuration
menu (see Sect. 10.1).
Display 1
********************
HUERNER
HST300 Print 315 2.0
********************
Display 2
Enter Fitting Code
14:32:11 21.10.12
Inp.Volt. 230V 50Hz
No Contact
Display 3
*** Welder Code ***
********************
