HunterDouglas SOLERA, Installation Operation And Care

Page: 18 / 24

OPERATION
16
Resetting Shade Programming
This reset erases all shade programming from memory, including group assignments, preventing
any input device from operating the shade. Its primary use is during installation to correct group
and network assignments. This reset does not affect travel limits.
1. Press and hold the manual control button for 12 seconds. The shade will move slightly once
after 6 seconds, then again after 12 seconds. Release the button.
2. Refer to “Joining a Shade to a Group” on page 16 to program the shade to a group.
Adjustment
Level the Rail(s)
■
Unsnap the fabric flap on the bottom or middle rail.
■
Each cord can be adjusted. Begin by
sliding the cord wedge(s) to release the
cord.
■
Place the bottom rail to the desired height.
■
Push cord wedge(s) back into place to
secure the cord position.
■
Snap the fabric flap back into place.
Troubleshooting
If your shade is not operating correctly:
■
First review the guide that came with your control device.
■
Refer to the following troubleshooting for specific solutions for your shade.
If questions remain, please contact the Hunter Douglas Customer Information Center at
1-888-501-8364.
Problem
The shade will not fit into the installation brackets.
Solution
If the shading has a battery wand, check that the wand is not interfering with
the installation brackets.
Check that the installation brackets are level and aligned. Shim (provided) the
installation brackets to level the headrail, if necessary.
Be sure the heads of the screws are flush against the installation bracket.
Check that the headrail is completely inserted into the installation brackets. See
“Mount the Headrail” on page 8
.
Wedge
Wedge