OPERATION
12
Joining a Shade to a Group
IMPORTANT:
The shade will not operate using the remote until it has been joined to
a group.
1. Press and hold
■
STOP on the remote until the indicator lights blink (approximately 6
seconds). The remote is now in programming mode.
2. Press the desired group number (1 – 6) on the remote. The backlit group number will flash
to show it is selected.
3. While pressing the programming button on the shade, press
▲
OPEN on the remote. The
green light flashes once and either the front shade or back panel will move slightly twice
(up, down, or down, up) to indicate the shade has joined the group. Release the
programming button.
4. Press and hold
■
STOP on the remote until the indicator lights stop blinking (approximately
6 seconds).
Basic Operation
1. To wake up the remote, simply pick it up or press
■
STOP. The last group(s) selected will be
highlighted and active.
■
Press “all” or groups 1 – 6 to select specific shade(s) to move. Selected group button(s)
will light to show they are selected.
➤
Multiple group buttons may be selected at a time.
➤
To deselect a group, press the group button again. The backlight for that group
button will go out.
■
Press
▼
CLOSE to lower the front shade and back panel to fully closed.
■
Press
▲
OPEN to raise the front shade and back panel to fully open.
■
Press
■
STOP to stop front shade or back panel movement anywhere along its travel.
■
Press the left arrow or the right arrow to lower the front shade to fully closed and raise
the back panel to fully open.
■
While a shade is in motion, press the opposite of shade motion (
▲
OPEN or
▼
CLOSE) to
reverse direction and move to fully open or fully closed.
■
Press
♥
FAVORITE to send selected shade(s) to your preset “favorite” position. Refer to
the PowerView
®
Automation Remote Control Guide on how to set a favorite position. The
default favorite position is the back panel at 50% open.
Summary of Contents for Duolite Shades
Page 22: ...Notes ...
Page 23: ......
