®
12
13
PGP
®
Rotor
Shrub Staking Kit
Secure installation of shrub rotors on
slopes and shrub areas.
The Hunter Shrub Staking Kit allows con-
tractors to install PGS & I-10 with ease and
security to assure complete sprinkler stability
and vandal resistance. The kit is used with a
5
⁄
16
" (8 mm) rebar stake and is then attached to
the sprinkler. The staking kit comes with one
plastic tie strap that is 14" (36 cm) long and
additional straps can be purchased if needed.
One strap is the preferred method, but the
staking kit will accept up to three straps. If the
installer prefers using a gear clamp instead of
the plastic strap, the slots on the staking kit are
wide enough to accept the clamp.
The Shrub Staking Kit reduces the potential
for injury by providing a protective covering
over the top of the rebar stake.
Easy to use:
1. Install the sprinkler on a riser.
2. Drive a
5
⁄
16
" (8 mm) rebar stake into the
ground, being careful not to hit the sprin-
kler piping system.
3. Insert the staking kit onto the rebar stake
and up against the sprinkler.
4. Insert the plastic strap through the staking
kit and around the sprinkler.
5. Pull the end of the strap so it is tight around
the sprinkler.
6. Clip off any excess strap that is remaining.
Easy to order:
Hunter part #46-3551
STAKING KIT
