Hunter Marine Family, User Manual

Page: 53 / 129

INTERIOR FURNITURE & BULKHEAD SPRAY FINISH
PAGE 30
Teak wood is a high quality, extremely dura-
ble wood with a high oil content. In order to
help you protect the original beauty of your
teak, we have sealed the interior with a (3 to
4) spray coat finish, using sealer and varnish
for marine cabinets. The materials are manufactured by
“
Chemcraft International
Inc
”
. This material will seal and protect the
wood from moisture and weathering. It is
easy to maintain and reduces work and
maintenance costs.
REPAIRS
When woodwork is damaged from scrapes or abrasions (that go into or through the finish), take
the following steps:
1) Sanding with the grain, take 320 grit sand paper to smooth out rough spots. If the spot is
down to the raw wood, rag (100% cotton) wipe the spot with acetone and allow to dry.
(Note: acetone only needs to be applied to the raw teak).
2) Reseal raw wood with Mohawk Spray Sealer (aerosol can) and allow to dry.
3) Lightly sand with 320 grit, sanding larger than original spot.
4) Wipe clean of dust and dirt with a clean rag.
5) Using Mohawk touch up and repair supplies, use clear lacquer spray (aerosol can). Apply
(1) coat on the spot evenly and allow to dry.
6) This process (steps 3
–
5) may be repeated as many times needed to bring damaged
area back up to its original finish. On your final spraying, be sure to feather into existing
finish.
SOP FOR POLYURETHANE (MINWAX) FLOORS
SURFACE SCRATCHES
1) Sand floor with 220 grit sandpaper until all scratches are removed.
2) Remove all dust with a clean cotton cloth or blow off with an air gun, then wipe down with
a tack cloth.
3) Apply one coat of minwax evenly over the sanded area.
4) Let the minwax dry completely (at least one day)
DEEP SCRATCHES
1) Sand floor with 220 grit sandpaper until all the minwax is removed and down to raw wood,
removing all blemishes.
2) Remove all dust with a clean cotton cloth or blow off with an air gun then wipe down with
a tack cloth.
3) Apply one coat of minwax evenly over the floor.
4) Let minwax dry 4-6 hours
5) Repeat steps 1-4, light sand
6) Apply a 3
rd
coat if needed by repeating steps 1-4.
7) Let the minwax dry completely (at least one day)
Chemcraft International
Telephone: 910-723-1846
U.S. Watts: 1-800-334-8556
Mohawk Finishing Products, Inc.
U.S. Watts: 1-800-545-0047