SATURN BOATS SECTIONAL FLOOR ASSEMBLY
Unfold the Hull
Clear a flat space (making sure it is clean and free of sharp objects) and unfold your boat. Remove the hull
from its box and take it out of the boat bag. Unroll the hull so it is laid out flat.
Inflate the boat slightly
The Inflatable Boats can be inflated either with a hand pump or with electric pump. The electric pump can
inflate the boats to a moderate pressure and save a lot of time, but boat will need to be finished off with a hand
pump. If you are using an electric pump you will need to make sure the inflation valve is in the “open” position.
When the valve is in the open position, air will freely move in/out of the valve. The valve can be opened by
pushing in the stem of the valve (middle portion in the center of the valve) and twisting it 90 degrees. To close
the valve, just twist the stem another 90 degrees and it will pop the stem out which represents the closed
position.
Inflate all hull chambers of the boat to approximately 30% full in order to make the floorboard insertion easier.
Floorboard Assembly
4-board model (14’ and smaller boats)
1. Place floorboard No.1 at bow part, No.4 at transom part, and No.2 + No.3 Make sure that keel valve
is located at the center of No.1 board's hole.
2. Press down No.2 + No.3 at the same time to be jointed well and flatly.
