Hunt Electronic HLC-8JMD, User Manual

Page: 55 / 82

c. WPS
WPS (Wi-Fi Protected Setup)
is an interface standard that allows users to
easily establish wireless network, and be free from complicated security
setting.
Please follow the steps for starting WPS. The menu and usage of every
router may be different from the sample pictures.
Set up SSID and pre-shared key on your wireless router. WPS only supports
WPA/WPA2 security. Do not select WEP security. Plug on the power adapter to
the IP camera.
Once the wireless connection of the camera has been established with the PC,
enter the wireless setting page, and check if the SSID of your wireless router is
listed in
Status of Wireless Networks . If yes, continue toward next step, no
other wireless settings are needed.
Access your router, and press the Connect button of the PBC (Push Button
Configuration) setting page on your router. Then use any hard & tiny little stick
to reach the WPS button within the hole where there is a word “Reset” right
under. The green light inside the camera at the back will start flashing.
When it finally stops flashing and lights constantly, it means the WPS
connection is successful. Refresh the wireless setting page on the camera; you
will see that the security settings have been already automatically completed.
Meanwhile you might see a message on your router page to inform you the
connection is OK.
If the light finally stops flashing but the lights are off, it means the WPS
connection failed.
Check your wireless router setting, and make sure the SSID of the wireless
router is found by the camera and listed in
Status of Wireless Networks .