Remove the two battery compartment lids by lifting upwards on the front lip.
Locate the connector hardware kit and the transducer hardware kit stored in the battery
compartments.
Refer to the illustration and route the transducer cable through the rear of the mount base. Insert
the power and transducer cable into the connector holder. The slots for the connectors are keyed
to prevent reversed installation, so be careful not to force the connector into the holder. The slots
for the connections are keyed to prevent reversed installation, so be careful not to force the
connector into the holder.
If you are also using the Temp/Speed accessory (Wide Optic and Wide Portrait only), install that
connector at this time also.
Carefully pull the excess cable from beneath the mounting surface so the connector holder aligns
with the mounting holes on the front of the mounting bracket.
Summary of Contents for Wide Portable
Page 1: ......
