background image

WHAT YOU HAVE 
 
 
The Humminbird Portable is available in several different configurations. You may have 
purchased the Portable case complete with a Humminbird fishfinder ready for operation. The 
Portable case is also available to adapt a Humminbird product you already own to portable 
operation.  
 
This manual serves for all applications and there may be minor differences in the hardware 
included depending on the configuration you purchased. 
 
The Humminbird Portable contains the portable case, a non-removable power cable, cable 
connector hardware kit, and a transducer mounting hardware kit. This kit contains everything 
necessary to adapt one of several different transducers to the portable (suction cup) mount. 
There are some parts included which may not be used depending on the type of transducer you 
have.  
 
Humminbird Portables are sold with Wide One Hundred, Wide 128, Wide Optic, and Wide Portrait 
fishfinders. Included are the portable case, a non-removable power cable, transducer mounting 
hardware, and the cable connector hardware kit. The type of transducer included varies with the 
fishfinder. 
 
This Operation Manual covers the assembly and operation of the Portable Case and transducer. 
Operation of the fishfinder is covered in the fishfinder Operation Manual. 
 
A phillips head screwdriver is required for installation. 
 
If you purchased a Portable Case with a fishfinder, additional mounting systems are available as 
accessories, which allow both a permanent mount and portable use of the same fishfinder. Refer 
to the Accessory catalog for ordering information. 
 
 
INSTALLATION 
 
PORTABLE CASE ASSEMBLY 
 
Your new Humminbird Portable case incorporates a quick-disconnect mount and connector 
system for quick and easy removal of your Humminbird unit from he case. The mount allows the 
unit to tilt 90 degrees for easy viewing from any location. 
 
Open the Portable case and disconnect the cover from the base at the hinge point. 
 
If the Humminbird unit is included, pivot it forward and remove it from the Portable case by 
depressing the latch on the rear of the unit, and lifting the unit from the mount. 
 

Summary of Contents for Wide Portable










Reviews: