Humminbird Piranha Portable, User Manual

Page: 9 / 14

MOUNTING THE CASE
NYLON WEB STRAP / REMOVING THE CASE AFTER USE
7. Press the center section and then twist the Piranha Portable case until it is facing
you. Six clicks produces maximum clamping and aligns the control head.
8. For fine-tuning, remove the Piranha Portable case and loosen the two screws.
Rotate the surface mount and retighten the screws.
Nylon Web Strap (not included)
There are multiple ways in which to strap your
Piranha Portable to your fishing platform:
1. Friction grooves, located on the left and
the right of the Piranha Portable case,
are specially designed to grip a standard
¹⁄₂
to 2 inch nylon web strap. With the
control head up you can make use of
the friction grooves by wrapping the
nylon web strap around the case.
2. Other ways of strapping that make use
of a
¹⁄₂
-inch nylon web strap that is positioned across the suction cup retainer
bridge, (see illustration above). This is useful when strapping to a seat or tube.
REMOVING THE CASE AFTER USE
1. With the boat engine off, loosen all cable retainers/clips holding the transducer.
2. Remove the case from the surface mount.
3. Remove the transducer from the surface
where it has been mounted.
4. Turn the case over, flip open the rubber cable
retainer by pulling on the tab located at the
upper left corner, and wrap the cable back
into the cable run, then push the cable under
the outer cable clip.
5. If you will not be using the unit again in
the near future, remove the batteries to
prevent corrosion, and store.
7
Control Head
Transducer Cable
Thumbknob
Pivot Knuckle
Piranha Portable Ready to travel
Power Cable
Cross strap for
Kayaks and
similar craft.
Through strap
for boat seats
or tubes
Top of permanent mounting
area,(press slightly to engage
Permanent Mounting Clip.
Surface mounting using straps