4
STEP 4
Release Locking Mechanism
•
Loosen the screw located in the center of the locking mechanism.
•
Let the inner tube fully rise then, while pushing down the tube,
flip down the tabs on the locking mechanism shaft.
•
The locking mechanism will be stored inside the inner tube.
STEP 5
Insert Cables
•
Feed half of the length of both monitor power cables and video cables
through the 3.25” hole.
*Do not feed any USB cables during this step.
STEP 6
Install Grommet Cover and Monitor Arm
•
Move to top of desk and install the Grommet Cover.
IF YOU ARE INSTALLING A SINGLE OR DUAL
MONITOR ARM, CONTINUE TO NEXT TASK.
IF YOU ARE INSTALLING AN M2, M8 OR M/FLEX,
PROCEED TO STEP 6 ON PAGE 8.
•
Attach the monitor stand to the column.
•
Feed all cables into the monitor stand.
Step 3
Mount main column to studded plate with plastic side facing rear and
secure with supplied lock nuts.
*Note studs are close to the column so a swivel socket works best.
Adjust foot of column.
*Do not over tighten foot as it will start to lift the desk.
Step 4
Loosen the screw located in the center of the locking mechanism.
Let the inner tube fully rise, then while pushing down the tube, flip down the
tabs on the locking mechanism shaft. The locking mechanism will be stored
inside the inner tube.
Step 6
Move to top of desk and install the Grommet Cover,
then the monitor stand to the column.
Feed all cables into the monitor stand.
Step 5
Feed half of the length of both monitor power cables and video cables
through the 3.25” hole.
*Do not feed any usb cables during this step.
Step 6
Move to top of desk and install the Grommet Cover,
then the monitor stand to the column.
Feed all cables into the monitor stand.
Step 5
Feed half of the length of both monitor power cables and video cables
through the 3.25” hole.
*Do not feed any usb cables during this step.
Step 6
Move to top of desk and install the Grommet Cover,
then the monitor stand to the column.
Feed all cables into the monitor stand.
Step 5
Feed half of the length of both monitor power cables and video cables
through the 3.25” hole.
*Do not feed any usb cables during this step.
Step 3
Mount main column to studded plate with plastic side facing rear and
secure with supplied lock nuts.
*Note studs are close to the column so a swivel socket works best.
Adjust foot of column.
*Do not over tighten foot as it will start to lift the desk.
Step 4
Loosen the screw located in the center of the locking mechanism.
Let the inner tube fully rise, then while pushing down the tube, flip down the
tabs on the locking mechanism shaft. The locking mechanism will be stored
inside the inner tube.
Summary of Contents for QuickStand Under Desk
Page 1: ...INSTALLATION INSTRUCTIONS ...
Page 12: ...HSQSUDIREV1 ...
