Human HumaStar 300, Service Manual

Page: 265 / 405

test Program
247
valve v5
To activate the valve, click on [

]
To stop the valve, click on [O]
At the end, stop the val-
ve by clicking on [O]
p3 puMp
To start pump click [

]
To stop pump click [O]
At the end, stop the val-
ve by clicking on [O]
p5 puMp
To activate pump click [

]
To stop pump click [O]
Before executing this test, position the Washing Arm
with its Probe inside one of the cuvettes as follows:
HOME plate, HOME Z
Enter parameter 355 inside “mm/10“
MOVE Z
Activate pump P8, by clicking on [

] to discharge the
liquids to waste.
At the end of the test, stop first P5 pump and then
pump P8 by clicking on [O]
(2)
16.3.1
p6 puMp
To activate pump, click [

]
To stop pump click [O]
Activate pump P6 only
when the incubation
bath is full, otherwise
use the function [TB Fill]
p7 puMp
To activate pump, click [

]
To stop pump click [O]
At the end, stop the
pump by clicking on [O]
p8 puMp
To activate pump, click [

]
To stop pump click [O]
At the end, stop the
pump by clicking on [O]
tb temp
Click on [TB Temp], the temperature is displayed on its
right. The display may vary
within ± 0,5 °C
tb fill
To fill the incubation bath with fresh bi-dust. Water,
click on [TB Fill] (it takes about 2 minuti), if necessary
repeat.
tb drain
To emptry the incubation bath, click [TB Drain] (it takes
about 2-3 minutes).
levelS
AWASH
WASH
TB LOW
TB HIGH
WASTE
Click on [Levels] to update the flags, colors, (label under
the key) as follows:
gReen -Level in the container is OK
Red - Level in the container is below minimum.
sopra il massimo
Level min. water in container for incubation bath.
Level min. Was Solution container
Level min. of water inside the incubation bath.
Level max of water inside the incubation bath
Level max contenitore.