Human HumaStar 300, Service Manual

Page: 308 / 405

gerätename | User manual
290
18.6.3 Reagent CHaMbeR
18.6.3.1 verify electronic alignment
1. Click in sequence on [pWR on] [HoMe z] [HoMe plate] [HoMe arm] [HoMe
dil] in section „Reagents“.
2. Insert a reagent bottle into position 1.
3. In section arm check, select “Bottle 1“ in menù “Position” and e click
[Move
aRM]
4. In section check probe, enter “200“ in space “mm/10“(decimals of millime-
ter) and click
[Move z]
to lower the probe.
5. Click [MiXeR] and make sure that during the rotation the probe does not
touch the collar of the bottle.
6. Click [HoMe z] [HoMe aRM] to reposition the probe Home.
7. If necessary verify also the Arm alignment (see „18.6.2.1 Check Electronic Ali-
gnment“) or execute the alignment of the Reagent Chamber. (see „18.6.3.2
Alignment of the Reagent Plate“).
18.6.3.2 alignment of the Reagent plate
1. Run all the operations as described in „18.6.3.1 Verify electronic alignment“.
2. Loosen slightly the holding screw of the encoder disk (2) (hexa key 1,5mm).
3. Move manually the Reagent Plate, by moving the motor pulley, and position
the Reagent Bottle exactly under the Reagent Arm.
4. Rotate manually the encoder disk (2) until the yellow LED DL3 and DL7 are lit
on the encoder board 17903/53 (1).
operation to be done
using the tester.exe.
„figure 54“ shows the positi-
on of flag (3) inside the opto
of Home (4) when the alignment
is done correctly.
operation to be done
with tester.exe.
figuRe 62