OPERATING MANUAL – ENGLISH
ASSEMBLY
Remove the height adjustment
screws from handles.
Slide handles into frame and insert
height adjustment screws to desired
height.
Place screw head through the
adjustment hole from the inside of
the walker frame (be sure the hex
screw fits into cut out in the frame.)
From the outside of the frame tighten
the black adjustment knob onto the
screw.
Ensure that all bolts are securely fastened before
using the walker!
Brakes must be in the parked/locked position before
sitting on the walker!
FEATHER TOUCH HAND BRAKING SYSTEM
1
2
3
4
5
1. Locking Nut
2. Tension Adjustment Screw
3. Housing
4. Handle
5. Brake Handle Arthritic Ball
When receiving your new walker, the brake system will be preset from the factory. To
maintain this preset position, be sure that the
Locking Nut
is tight against the
Housing
.
This is the same for the
Tension Adjustment Screw Locking Nut
located at the rear wheel.
(To adjust see: Brake Usage/Adjustment)
USING YOUR WALKER
This walker is designed for use as a walking aid and should never
be used for any other purpose.
TO SIT,
touch the back of your legs to the edge of the seat to ensure position of
walker before sitting down.
DO NOT
support your weight on the handles when attempting to sit. Use the
handles to stabilize your body as you carefully turn around. Keep your handles
on the foam handles and slowly lower your weight onto the seat.
IMPORTANT:
Test to be sure walker
will not roll before attempting to sit.
Brakes must be in parked/locked
position.
Ensure when walking your path is clear and free of obstacles to
avoid injury and damage.
To install/remove backrest on WX and SWX models, pull up on the backrest
knob (1) and insert the backrest into the backrest connector located on the
frame. Once inserted, release the backrest knob to hold into position.
1
1
To install basket, simply hook onto
frame.
