7
2.2 Attention
* The knob on the panel can’t change or adjust with a rush otherwise it will be damaged.
* Check the connection to see if the welder input and output cables are well connected, whether the
earth (ground) connection is reliable, etc.
* Never allow anybody else other than the operator himself to dislocate or modulate the welding
machine.
* Welders have strong electromagnetism and frequency interference, so keep away people with heart
pace or the articles which can be interfered by electromagnetism and frequency.
* No using the way of knocking the torch head to remove slag.
* The torch cable cannot be pressed and its folding angle cannot be too small. The liner radius cannot
less than 150mm, or it may damage the inner cable and lead to accident.
* Never allow anybody else other than the operator himself to access the job site.
* No switching when welding.
* No touching on the electrified parts such as output interface etc. when welding.
* No touching on any other electrified parts while turning on power. Power must be cut off after finishing
job or leaving the site temporarily.
2.3 Safety protection for installation
* Precaution must be taken to keep the operator and the machine from the foreign materials falling from
up above.
* The dust, acid and erodible dirt in the air at the job site can not exceed the amount required by the
mode (excluding the emission from the welder).
* Inflammable or explosive materials are prohibited to access the job site.
* The welder must be installed in the place where it can not be exposed to sun and rain. Also it must be
stored in less humid place with the temperature range at
﹣
10
～
40
℃
.
* There should be 50
㎝
space about for the welding machine to have good ventilation.
* Make sure that there is no metal-like foreign body to enter the welding machine.
* No violent vibration in the welder’s surrounding area.
* Make sure that there is no interference with the surrounding area at the installation site.
2.4 Safety Checking
Each item listed below must be carefully checked before operation:
* Make sure that the welding machine has reliable earth connection.
* Make sure that there is always sound output and input wire connection instead of exposing it outside.
Regular check needs to be conducted by the qualified personnel after the welder has been installed over
a period of six months, which involves as follows:
* Routine cleaning needs to be done to make sure that there is no abmodeal loose parts happening in
the welding machine.
* The parts installed on the panel must guarantee that the welder works properly.
* Check the welding cable to see if it can continue to be used before it is worn out.
* Replace the welder’s input cable as soon as it is found to be broken or damaged.
* Make sure whether there is enough power supply to make the welding machine work properly and the
input power must load the safety protection device.
Notice: Cut off the power supply before opening the case to check.
Please do not hesitate to contact us for technical assistance whenever you come across the problems
you can not work out or you may deem difficult to fix.
