5
Sites West of the Satellite- Subtract 90 (-90)
Or Simply, if your calculated value is negative add 90, if your calculated value is positive subtract 90.
22.
Set your RFU polarization by rotating the unit Counter Clockwise for setting a negative polarization
value or Clockwise for setting a positive polarization value as viewed from the rear of the RFU. Note
that the RFU pictured below is currently set to Zero (0)
23.
Once the coarse antenna pointing values (shown above) have been obtained and the DAPT is inline on
the Rx IFL cable at the RFU, select
Display Signal Strength
and begin the antenna pointing process.
as seen at the DAPT
24.
Peak the antenna for the best obtainable SQF by adjusting the Azimuth and Elevation of the Antenna.
Once complete, close the Signal Strength indicator and select
Next
at the Rx Antenna Pointing page in
order to begin Tx Antenna Pointing (Auto Cross-Pol) (ACP).
Summary of Contents for HX200
Page 10: ...10 Appendix A RFU Antenna Assembly ...
Page 12: ...12 STEP 3 STEP 4 ...
Page 13: ...13 ...
