![Hughes HN9500 Installation Manual Download Page 31](http://html.mh-extra.com/html/hughes/hn9500/hn9500_installation-manual_2182047031.webp)
Figure 8: Attaching or removing the HN9500 pedestal base
Removing the base
If you need to remove the router from the pedestal base:
1.
Pull the release tab on the bottom of the base down
2.
Slide the base away from the router.
Powering up the router
For this task you must have the satellite router and the correct power supply. To make sure you
have the correct power supply, see
on page 12.
Test the power outlet and power up the satellite router:
1.
Use an AC outlet tester to verify that the power outlet is wired correctly.
Wiring problems may include:
• Hot and neutral wires reversed
• Neutral and ground wires reversed
• Open ground (incomplete connection)
• Open neutral
If the outlet is wired improperly, notify the customer that you are not permitted to connect
the system to a faulty outlet. Do not proceed with the installation until a properly wired outlet
is provided.
2.
Connect the DC power cord to the router’s DC IN connector, as shown in
on page 18.
3.
Connect the AC power cord to the three-prong connector on the router’s power supply.
4.
Connect the surge connector (recommended) to an AC power outlet.
17
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 3
Installing the satellite router
Summary of Contents for HN9500
