Hughes HN9500, Installation Manual

Page: 104 / 136

Corrective action Explanation State name State code
See Table 6: Reasons for
registration errors and corrective
actions
on page 36.
Router is in commissioning phase:
registration with the NOCC has
failed. ST Registration Failure 17
Transient – No action is necessary. Router is in commissioning phase;
router is waiting for capacity keys
from the NOCC. Waiting for Capacity
Keys 18
Transient – No action is necessary. Router is in commissioning phase;
router is reconciling profiles with
the NOCC. Reconciling Profiles in
Commissioning 19
Transient – No action is necessary. Router is in commissioning phase
and is downloading operational
software. Downloading
Operational Software 20
Note: State codes 1 – 20 appear only while the router is being installed or during a hard reboot (resulting
from power being removed and then restored).
Operational phase
Transient – No action is necessary. Router is starting up in operational
phase. Starting Up in Operation 21
Transient – No action is necessary. Router is in operational phase.
Downlink has been established; Downlink Established in
Operational 22
that is, beacon is being tracked and
transmission information packets
are being received.
Transient – No action is necessary. Router is in operational phase and
is waiting for indirect and direct
management packets. Waiting for MIPs in
Operational 23
Transient – No action is necessary. Router is in operational phase.
Profiles are being distributed to
various subsystems. Reconciling Profile in
Operational 24
Steady state – No action is
necessary. Router is fully operational. Fully Operational
(normal operation) 25
Error codes
Check for loose, disconnected, or
faulty receive cable. Rx cable connectivity tests have
failed. Rx Connectivity Down 26
Verify cabling and pointing. If
antenna has moved or been
disturbed, repoint it. Router is unable to track beacon. No Beacon 27
Verify cabling and pointing. If
antenna has moved or been
disturbed, repoint it. Router is not receiving
transmission information packets
from satellite. No TIPs 28
Check for loose, disconnected, or
faulty transmit cable. Tx cable connectivity tests have
failed. Tx Connectivity Down 29
Rain or snow can cause this
condition. If it continues during Bad slots are transmissions from
the router that are not received by
Too Many Bad Slots 30
HN9500 Satellite Router Installation Guide
90
1037736-0001 Revision G
System Control Center Chapter 9