Hughes HN9000, Installation Manual

Page: 24 / 126

Figure 6: Power supply for the HN9000 satellite modem
Before proceeding, make sure you have the correct power supply. Check the part number on the power supply and refer
to
Table 3: Power supply specifications for the HN9000 satellite modem on page 10.
• Always use the power supply provided with the satellite modem. The modem's performance may suffer if the wrong
power supply is used.
• The input must be 110/130 VAC.
• A suitable surge protector is recommended to protect the satellite modem from possible damage due to power surges.
• If the satellite modem is installed outside the United States or Canada, observe the power standards and requirements
of the country where it is installed.
Table 3: Power supply specifications for the HN9000 satellite modem
Power cord Electrical requirements Application
Power supply type and part
number
Detachable, for 110
VAC outlet type. Input line voltage:
100 – 130 V, 2 A maximum
HN9000 satellite modem
with 1-W or 2-W radio AC/DC, 73 W
P/N 1501006-0001
Input line frequency:
60 Hz AC
Rated power consumption: 73 W
If there is any reason to remove power from the satellite modem, always unplug the AC power cord from the power
source (power outlet, power strip, or surge protector). Do
not remove the DC power cord from the modem’s rear panel.
Doing so could result in an electrical shock or damage the modem.
When you re-apply power to the modem, plug the AC power cord into the power source.
Primary tools and equipment needed for installation
To install the satellite modem, you need the following items, which are included in the satellite modem shipping carton:
• Satellite modem.
• Power supply.
10
HN9000 Satellite Modem Installation Guide
1037576-0001 Rev. A
Chapter 2