Hughes HN7700S, Installation Manual

Page: 19 / 140

Chapter 2 • Preparing the HN router for installation
1037753-0001 Revision A
5
Chapter 2
Preparing the HN router for installation
This chapter discusses preparations you must make prior to
installing the HN router and information you should know before
beginning the installation.
This chapter discusses the following tasks:
•
Items required for installation on page 5
•
Confirming installer PC and site requirements on page 6
•
Customer site requirements on page 7
Items required for
installation
The HN router and the transport device shipping cartons contain
the equipment necessary for installation. Before beginning the
installation make sure you have all of the items shown in Figure 2
on page 6 and any other materials you may need.
Note: Install your trasport device before installing the HN router.
The appendices listed below give the installation instructions for
the trasport devices.
•
Appendix E – ADTRAN Total Access 600R, on page 99
•
Appendix F – Siemens 4100/4101 DSL Modem, on page 117
Note: Customers who purchased their system from a Hughes
retail channel receive an order confirmation e-mail.
Note: If the site has a DC power source, it will require a DC/DC
power supply. See
Table 2 on page 11
. You must provide the
wire required to assemble the DC input power cable.