HUGH CRANE (Cleaning Equipment) Ltd –
COMMANDO
®
ROTAWASH
Page 5
DEPLOYING THE
COMMANDO
®
ROTAWASH FOR USE
On arrival at the work site select a suitable location for the
COMMANDO
®
ROTAWASH.
Set the unit down in the required position.
Support the infeed conveyor and unclip the over-centre latch, lower to horizontal and when
lowered ensure the support leg is fully in position. Ensure that the plastic drive chain drops
into its guide channel and is located correctly on its sprockets.
Although the conveyors are fitted with gas struts to arrest the fall rate, be aware they
could drop so do not stand directly under them when lowering.
Support the outfeed conveyor and unclip the over-centre latch, lower to horizontal and when
lowered ensure the support leg is fully in position.
Although the conveyors are fitted with
gas struts to arrest the fall rate, be aware they could drop so do not stand directly
under them when lowering.
Remove the guide rails from the transport sockets and fit them in the appropriate conveyor
pockets, adjust the rails by loosening the grub screws in the elbows and rotate into correct
position, once in position tighten the elbow and conveyor pocket grub screws.
OVERCENTRE LATCH
SAFETY PIN
SUPPORT LEG IN POSITION
TRANSPORT SOCKETS
CONVEYOR POCKET
ADJUSTING GRUB
SCREWS
