6. Flight Training
11
5.4 Fitting the LiPo battery
The supplied LiPo battery is mounted inside a cradle on the underside of your
helicopter’s fuselage.
The LiPo battery should be mounted
with its connecting cables facing
towards the rear or the helicopter
DO NOT connect the cables at this time
Your RC helicopter is an easy-to-fly model built, you don’t become an expert pilot
without taking time to learn the basics. As the saying goes:
In other words, if you don’t want your first few flights to end in a pile of mangled
wreckage-requiring expensive repairs to your new model – take the time to follow this
brief Flight Training Program. After all, learning to fly your helicopter is all part of the
enjoyment!
6.1 Power-On (Failsafe) Procedure
Your RC helicopter’s 4-in-1 Gyro Receiver is fitted with a Power-On failsafe.
This is designed to ensure that the helicopter’s motor will not start unless it detects a
suitable radio-control signal when the LiPo battery is connected. The correct Start-Up
sequence is as follows:
8
4.3.2. ELEV SENSIVITY SET UP- NOR MODE
Hold down ENT key for 1 second to enter setting status.Enter set sensitive status by
up/down key,Press ELEVATOR TRIM KEY to idea sensitivity and then hold EXT key
for 2 seconds to confirm and exit.
4.3.3 AILE SENSIVITY SET UP- NOR MODE
Hold down ENT key for 1 second to enter setting status.Enter set sensitive status
by up/down key,Press AILERON TRIM KEY to idea sensitivity and then hold EXT
key for 2 seconds to confirm and exit.
5805
HUBSAN
7.7V
Set reverse X
Set sensitive -
Elevator 40
Aileron 50
Rudder 50
Plane type Helicopter
Expert mode No
Stick mode Mode 2
5805
HUBSAN
7.7V
Set reverse X
Set sensitive -
Elevator 40
Aileron 50
Rudder 50
Plane type Helicopter
Expert mode No
Stick mode Mode 2
5805
HUBSAN
7.7V
Set reverse X
Set sensitive -
Elevator 40
Aileron 50
Rudder 50
Plane type Helicopter
Expert mode No
Stick mode Mode 2
4.3
SENSITIVITY SET UP
4.3.1 RUDDER SENSITIVITY SET UP- NOR MODE
Hold down ENT key for 1 second to enter setting status.Enter set sensitive status
by up/down key,Press RUDDER TRIM KEY to idea sensitivity and then hold EXT
key for 2 seconds to confirm and exit.
