6
4.2 Reversing channel setup
4.2.1.ELEV REVERSE SET UP
Hold down ENT key for 1 second to enter setting status,Press ENT key to enter
reverse setting status,Press ENT key to choose reverse,and then hold EXT key for 2
seconds to confirm and exit.
4.2.2. AILE REVERSE SET UP
Hold down ENT key for 1 second to enter setting status.Press ENT key to enter
reverse setting status.Move arrow to Aileron by up/down key ,Press ENT key to
choose reverse and then hold EXT key for 2 seconds to confirm and exit.
4.2.3. THRO REVERSE SET UP
Hold down ENT key for 1 second to enter setting status.Press ENT key to enter
reverse setting status.Move arrow to Throttle by up/down key ,Press ENT key to
choose reverse and then hold EXT key for 2 seconds to confirm and exit.
5805
HUBSAN
7.7V
Set reverse -
Elevator Normal
Aileron Reverse
Throttle Normal
Rudder Normal
Set sensitive X
Plane type Helicopter
Expert mode No
Stick mode Mode 2
5805
HUBSAN
7.7V
Set reverse -
Elevator Normal
Aileron Reverse
Throttle Normal
Rudder Normal
Set sensitive X
Plane type Helicopter
Expert mode No
Stick mode Mode 2
5805
HUBSAN
7.7V
Set reverse -
Elevator Normal
Aileron Reverse
Throttle Normal
Rudder Normal
Set sensitive X
Plane type Helicopter
Expert mode No
Stick mode Mode 2
15
6.4 Basic Maneuvering
3.Once you have turned your helicopter, place your right thumb over the tip of the
cyclic joystick and S-L-O-W-L-Y press forwards.
The lower rotor will tilt forward. The helicopter’s nose will pitch down. Your helicopter
will begin to move forward.
Tip- Be ready to slightly increase your Throttle power, as the helicopter is likely to
lose a little height during maneuvering. Also remember that the swash plate on the
helicopter links all of your cyclic controls; so don't be surprised if your helicopter
moves slightly to the left/right as well as forwards. As you gain experience, you will
stop thinking in terms of Left/Right or Forwards/Backwards and start to automatically
synchronize cyclic joystick corrections, just like flying a full size helicopter.
(MODE 2)
(MODE 1)
(MODE 2)
(MODE 1)
In this Flying Lesson you will use the cyclic joystick and the Rudder to maneuver
your helicopter.
1.Keeping a safe 1 to 2 meters from your model, S-M-O-O-T-H-L-Y advance the
collective Throttle joystick until your helicopter reaches approximately shoulder
height.
2.S-L-O-W-L-Y apply collective Rudder control to point the nose of your helicopter in
the direction you wish to fly.