3
2.3 PREVENT MOISTURE
R/C models are composed of many precision electrical components.
It is critical to keep the model and associated equipment away from condensation and
other contaminants. Exposure to water or moisture may cause the model to
malfunction resulting in loss of responsiveness, or a crash.
2.4 PROPER OPERATION
For the safety purpose, please only use hubsan’s spare parts for replacement.
2.5 ALWAYS BE AWARE OF THE ROTATING BLADES
When in operation, the main and tail rotor blades will be spinning at high speed. The
blades are capable of inflicting serious body injury and damage to the environment.
Be cautious of your actions and careful to keep your body and loose clothing away
from the blades. Never take your eyes off the model or leave it unattended while it is
turned on. Once landed, immediately turn off the model and transmitter.
2.6 AVOID FLYING ALONE
Beginners should avoid flying alone whilst learning flight skills. It is advised that an
experienced pilot be on hand for guidance.
It is recommended to practice with a computer-based flight simulator.
CAREFULLY INSPECT BEFORE REAL FLIGHT
• Before operation, please check the batteries of the transmitter and receiver are
charged enough for the flight.
• Before turning on the transmitter, please check that the throttle stick is in the
minimum position.
• Check for any missing or loose screws and nuts. Carefully check main rotor blades
and rotor holders. Broken or premature failure of parts will result in a dangerous
situation.
• Check all the ball links to avoid excess play and replace as needed. Failure to do so
will result in poor flight stability.
• Check the battery and power plug are securely fastened. Vibration and violent flight
may cause the plug to loosen resulting in loss of control.
• When turning on the unit, please follow the power on/off procedure: for Power ON-
please turn on the transmitter first, and then turn on the receiver. For Power OFF-
please turn off the receiver first and then turn off the transmitter. Improper procedure
may cause loss of control of the helicopter.
3 SAFETY CHECK BEFORE FLYING
18
Remember, your helicopter is designed for indoor operation, where low-speed
precision-control is paramount. When flying in the great outdoors - even though you
may think it’s absolute flat calm - you will notice that your helicopter is susceptible to
almost imperceptible air currents. This presents an interesting challenge for the
experienced pilot, but could spell disaster if attempted too soon. So, take your time
and practice the Flying Lessons described in this manual until you have acquired
proficiency in the Advanced Maneuvers.
Make sure it really is a flat calm day outside. And remember that outdoor flight is a
whole new learning experience.
Flying your radio-controlled helicopter outdoors really is great fun. Just remember its
design limitations and be prepared to make the professional pilot’s decision to cancel
your plans and you helicopter will live to fly another day.
There are Old pilots, and there are Bold pilots……
But, there are no Old Bold pilots!
7. Video recording
Note:
Before inserting or removing SD card, the power switch must be turned off.
Always stop the video recording function and power off the battery firstly, and then you
can take out the SD card.
7.1
pls find the SD card slot in the bracket
module, which is below the helicopter.
7.2
Insert the SD card
Note: Avoid removing the SD card and
re-inserting again too quickly, otherwise, the
recording module won’t work properly.
