Pub. 42004-438M
300 Series Emergency Telephone Manual
Page 45 of 50
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-438M.docx
04/19
3.
Press
***
to enter programming mode.
4.
Wait two seconds.
5.
Enter
**0000
(0000 is the factory default maintenance PIN number).
6.
Enter
*20
.
The telephone will respond with six DTMF tones if it successfully enters maintenance mode. Two
DTMF tones are emitted if access is denied. Repeat steps three through six if access is denied.
7.
Press
*8321
.
A short beep is emitted to indicate that the telephone is in recording mode.
8.
Record the message in a conversation-level voice.
9.
Press
*
when the recording is complete.
The recording automatically plays back when the
*
DTMF code is pressed.
Maintenance
WARNING
—Always remove power to this station prior to servicing.
Battery Replacement (Voice Annunciation Option Only)
CAUTION
—Risk of explosion if battery is replaced by an incorrect type or is incorrectly
replaced. Dispose of used batteries according to the instructions.
Replace with lithium AA batteries to ensure proper cold weather operation and maximum battery life.
General Information
1.
Inspect and replace frayed or cracked wiring.
2.
Secure/replace loose wires and terminal lugs.
3.
Remove corrosion from terminals.
Service
Contact GAI-Tronics regional service center for a return authorization number (RA#) if a RED ALERT
®
telephone requires depot repair service. Equipment must be shipped prepaid to GAI-Tronics with a return
authorization number and a purchase order number. Repairs will be made without charge if the
equipment is under warranty. Please include a written explanation of all defects to assist our technicians
in their troubleshooting efforts.
Call 800-492-1212 inside the USA or 610-777-1374 outside the USA for help identifying the regional
service center closest to you.
