LIGHTING CONTROL PANELS
INSTALLATION INSTRUCTIONS
9601 Dessau Road, Building One
|
Austin, TX 78754 Toll Free: 888-698-3242
|
Fax: 512-450-1215
|
www.hubbell-automation.com
INSTALLATION OVERVIEW
The installation instructions contained in this document are provided as a guide for proper and reliable installation. The
mounting location should be selected and prepared based on the application. All electrical wiring and mounting hardware
(i.e. electrical mounting box, conduit, etc.) should be prepared with consideration of the requirements outlined in the wiring
and mounting diagrams below.
These instructions include information as follows:
Description
Product Configurations
Enclosure Mounting
Installing Individual Relay Cards
Connecting Panel Power
Connecting Lighting Loads
Connecting Low Voltage Inputs
Operating the Panel
Troubleshooting
Panel Specifications
Panel Load Schedule Form
PRECAUTIONS
•
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
•
CAUTION - RISK OF ELECTRICAL SHOCK.
To prevent electrical shock, turn off power at the circuit breaker before
installing or servicing unit. Never wire energized electrical components.
•
NOTICE:
For installation by a licensed electrician in accordance with National and/or local Electrical Codes and the
following instructions.
•
CAUTION: USE COPPER CONDUCTOR ONLY.
•
Be sure to read and understand all instructions before installing or servicing unit
•
For Indoor use only. Do not use outdoors.
•
Do not mount near gas or electric heaters.
•
Disconnect switch or a circuit breaker must be provided and marked as the disconnecting device.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Confirm that device ratings are suitable for application prior to installation.
•
No user serviceable parts contained inside unit. Refer all service related questions to the factory.
•
All servicing shall be performed by qualified service personnel.
•
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
•
Use only approved materials and components (i.e. twist on connectors, electrical box, etc.) as appropriate for
installation.
•
NOTICE:
Do not install if product appears to be damaged.
•
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may
be impaired.
•
Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
™
3452B 3.17.2016
