5
0~110V/ 110~220V by control “ON/ OFF” button.
12.Computer interface: for debugging device, downloading programs and updating
13.Power switch: Device power switch.
14.Power outlet.
15.Grounding terminal.
16.Contrast adjustment: adjust the brightness of LCD.
V.Usage Method
1.Voltage and current
Power on, select output current terminal or voltage terminal, Press “Output
selection”terminal, press “ON/ OFF”button,Device shows simulation failure state, you can
adjust knob to control AC/DC voltage and current output.
2.Auxiliary Output DC voltage and current
First, cycles the potentiometer to zero, connect the output line, select the required
voltage value(0V or 110~220V),then press output button, adjust potentiometer ,you will
find voltage and current output; You only need press “Output Selection” to external input,
and connect output to external input voltage and current terminal, or to external Voltmeter
and Ammter.
3.Resistance ( single resistor 50w ), capacitors usage
First, disconnect the U - shaped short tab on the Rx, then select the appropriate value
resistance or capacitance in series, and connect as following three figures.
Figure 5-1 String into a resistor 500 ohm/50W
