6
Function
module
Instructions
Test
connection
area
Yellow, green, red and black four-color junction seats correspond to
three-phase A, B, C and neutral point O respectively, and correspond to
the test line (yellow, green, red, black). The other end of the test line has
yellow, green, red and black four-color test pliers, which correspond to
the tested transformer A, B, C, O bushing (if there is no neutral point O
bushing, the black test pliers can be suspended).
Antenna
seat
Please connect special rubber rod antenna for wireless temperature
measurement signal reception.
Display
5.6 inch large industrial high brightness color LCD screen, display
operation menu and test results.
Button
Operate instruments. “↑↓” is the "up and down" key, select to move or
modify data; “←→” is the "left and right" key, select to move or modify
data; "Enter" key, confirm the current operation; "Cancel" key, abandon
the current operation.
Power
switch
The power switch of the whole machine is switched to the open position
when it is switched on. Switch to the close position when it is switched
off.
Function
module
Instructions
RS 232
interface
Connect external printer.
Charging
interface
Use instrument charger to recharge
USB
interface
External USB disk is used to store test data, please use FAT or FAT32
format U disk; in the storage process, it is strictly prohibited to dial out the
USB disk.
X. Operation Instructions
Three-phase tested product test wiring
The yellow, green, red and black clamp of the test line shall be connected with the A,
B, C and O sleeves of the tested product respectively (if there is no neutral O casing, the
black clip can be suspended). At the other end of the test line, connect the yellow, green,
red and black terminals of the meter by color.
Single-phase tested product test wiring
The red and black test clamp of the test line connects the two ends of the tested
product; the other end of the test line connects the red and black terminal
of
the
