Huawei U-SYS IAD101H, Quick Start Manual

Page: 16 / 19

4
Configuration (Command Line Mode)
U-SYS IAD101H/102H/104H Integrated Access Device
Quick Start
14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 02 (2011-02-09)
2. Select
Obtain an IP address automatically
on the PC that is connected to the
LAN port of the IAD. The IAD then allocates a LAN IP address to the PC, such as
192.168.100.10.
To access network by the preceding method, ensure that the IAD is in the NAT (Network
Address Translation) mode. Run
display nat
in the global configuration mode to check that
whether the IAD is in the NAT mode. If the CLI does not display that
NAT is started
,
run
nat enable
to enter the NAT mode.
4.6 Setting the UCEMS Parameters
On the IAD, you can set the basic parameters for the communication with the Unified
Communication Element Management System (UCEMS) so that the IAD can accept
the management from the UCEMS.
Before setting the UCEMS parameters, run the display physical-serial-num command
to view the physical serial number. If the configuration is inconsistent with that on the
UCEMS (To obtain the physical serial number set on the UCEMS, contact the network
administrator), run the physical-serial-num command in the global configuration mode
of the IAD to synchronize the physical serial number.
Generally, only the IP address of the UCEMS needs to be configured. For example, run
the nms primary command to set the IP address of the UCEMS to
192.168.1.201
. The
operation is as follows:
TERMINAL(config)# nms primary 192.168.1.201
Run
display nms
to view status of the IAD registering to the UCEMS.
TERMINAL# display nms
the config is IP
------------------------------------------------------------------
------