U-SYS IAD101H/102H/104H Integrated Access Device
Quick Start
4
Configuration (Command Line Mode)
Issue 02 (2011-02-09)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13
TERMINAL(advanced-config)#
exit
Step 5
Run the sip user command to set the users for port 0 and port 1.
TERMINAL(config)#
sip user 0 id +862821010300 password 111 name
TERMINAL(config)#
sip user 1 id +862821010301 password 111 name
The SIP user information on the IAD can be registered with the SIP server successfully only
after the SIP user information is configured on the SIP server.
After the configuration is complete, you can view the configuration result. For example,
view SIP user attributes of port 0.
TERMINAL(config)#
display sip attribute 0
Sip User Information
-----------------------------------------------------
user-sn : 0
id : +862821010300
password : ********
name : [email protected]
local address : 192.168.1.203
local-port : 5060
registration state : registered
expire-time : 120 sec
previous server : 0.0.0.0 : 5060
current server : 191.168.10.20 : 5060
dm match delay : 0 ms
digit-map position : remote
After the registration is successful, two registered users can talk with each other. For
example, if the phone connected to port 1 dials
21010300
, the phone connected to port
0
rings.
862821010300 consists of country code +86, area code 28, and local number
21010300. To make a local call, dial 21010300. The dialing rule is set in the IMS.
Step 6
Run
write
to save your settings.
----End
4.5 Accessing Network Through the IAD
A PC can access the network through the IAD101H, IAD102H, and IAD104H.
For example, to configure a PC to access the network through the IAD102H, do as
follows:
1.
Connect the PC to the LAN port of the IAD, and the WAN port to the uplink, as
shown below.
Summary of Contents for U-SYS IAD101H
Page 2: ......
