5
Powering On the Charging Module and
Setting Parameters
●
After the installation is complete, power on the charging module. Use a
multimeter to check whether the voltage at the cabinet copper bar connected
to the output connector of the charging module is within the normal range
(150–500 V DC in low-voltage mode and 150–1000 V DC in high-voltage
mode).
●
Check that the power indicator on the charging module is steady on and the
voltage displayed on the nixie tubes is the same as that measured by the
multimeter.
●
Set the hardware address of the charging module if grouping is required.
R100020G1 Charging Module
User Manual
5 Powering On the Charging Module and Setting
Parameters
Issue 05 (2021-11-16) Copyright © Huawei Digital Power Technologies Co., Ltd.
30
