16
Open the mobile phone app and go to the homepage.
Select
Stock
to access the
Stock
page.
Click
+
in the upper right corner and choose
Ibat Collection
.
On the
IBAT Scan
page, click
to collect iBAT SN info.
Click
Save
in the upper right corner. The collected
information is saved in CSV format and stored in the
BatteryApp
path.
Locate the doc that stores iBAT SN and upload it to the
computer. Save sequence numbers of iBATs related to
the same iBOX a CSV file according to the battery
sequence numbers.
6. Hold down all iBOXs networking switch for 2 seconds. The ALM indicator blinks red once, and
the RF_Z indicator turns from steady green to blinking green at super short intervals, which
indicates that the iBOX is being networked.
7. Hold down all iBATs networking switch for 2 seconds. When the RUN/ALM indicator turns from
steady red to blinking green at short intervals, and finally to blinking green at long intervals, the
iBAT connects to the iBOX network.
8. After all iBATs are successfully connected in the parallel network, when the RF_Z indicator on
the iBOX turns from blinking green at super short intervals to blinking green at long intervals, the
networking is complete.
• You can manually enter SN
on the
Service Expert
app to
collect the iBAT SN
information.
• Save the iBAT information file
in CSV format.
• It is recommended that the
names of CSV files
correspond to different iBOXs.
NOTE
4. On the
iBOX Web
page, select
System Settings > Parallel Net Join Config
, and set
Parallel
Net Join Status
to
Enable
.
5. Perform
iBAT SN number import
to import the iBAT SN information to the corresponding iBOX.
•
Set
Parallel Net Join Status
to
Enable
for all iBOXs.
•
Ensure that the configured number of batteries is consistent with the number of scanned
batteries. Otherwise, the import fails.
NOTE
Do not operate the networking switch during networking. Otherwise, the networking fails. You need to
clear the network parameters for the iBOX, set
Parallel Net Join Status
to
Enable
, and separately
press the networking switch for 2 seconds on the iBOX and on the iBAT for which the network
parameters have been cleared when the iBOX network parameters are cleared, to complete the
networking again.