Wired Controler
+7:
XK60
23
ĸ
. If quite function is set, turbo function will be canceled.
3.19 Ultra-Dry Setting
Under Dry mode, when the setting temper
ature is 16°C, press “
▼
” button twice
and the setting temperature will be changed to 12°C, at this time, the unit enters the
Ultra-Dry function.
When the Ultra-
Dry function is activated, it can be cancelled by pressing “
▲
”
button or pressing “Mode” button
to switch mode.
3.20 Other Functions
3.20.1 Lock Function
Under the ON state of the unit without any malfunction or under the OFF state of
the unit, press
▲
and
▼
buttons at the same time for 5s till the wired controller enters
the lock state. In this case, LCD displays
. After that, repress these two buttons at the
same time for 5s to quit the lock state.
Under the lock state, no response will be given to the other button operation.
3.20.2 Memory Function
Memory switchover: Under the OFF state of the uni
t, press the Mode and
▲
buttons at the same time for 5s to switch memory modes. When setting the memory
mode, “MEMORY” will be displayed. If this function is deactivated, the unit will go to the
OFF state after power recovery.
Memory recovery: If the memory function is On, the wired controller after power
failure will resume its original running state upon power recovery.
Note:
It will take about 5 seconds to save data. Therefore, please do not cut down the
power at this time, or data will fail to be saved.
3.20.3 Selection of Centigrade and Fahrenheit
Under the OFF state of the unit, press the Mode and
▼
buttons at the same time
for 5s, Centigrade and Fahrenheit scales will be switched alternately.
3.20.4 Ambient Temperature Enquiry
Under On/Off status, press “Confirm” button for 5s, it will enter Enqu
iry interface. At
this time, what shows on the timer area is the ambient temperature type: 01 or 02 and
the temperature will be shown. “01” means the outdoor ambient temperature and “02”
represents the indoor ambient temperature. Press “Mode” button to swi
tch between
