HTC CE-8201, Manual, Page: 14 / 19

- 13 -
9.9 Alarm Settings
1) In the menu selection, select the "alarm function" function, press the TEST key to enter
2) The alarm thresholds for four measurement functions can be set.
3) After entering the alarm function interface, you can switch the set alarm type by short
pressing the ▲ key or the ▼ key.
4) After confirming the alarm type, short press the TEST key to enter the alarm state
selection, and then short press the ▲ key or the ▼ key to switch between setting greater
than alarm (>) or less than alarm (<).
5) After confirming the alarm status, you can short press the TEST key to enter the alarm
threshold modification status, short press the ▲ key to decrease the step or short press
the ▼ key to increase the step to modify the threshold.
6) Long press the ▲ key to move the threshold step cursor to the right, and long press the
▼ key to move the threshold step cursor to the left.
7) Short press the TEST key again to save the current settings and exit.
8) Or short press the MENU key to return to the previous layer, short press the MENU key
in the layer where the alarm type is selected to return to the menu interface.
9) Long press the MENU button on any interface to enable or disable the alarm function.
10)
X. Battery Instructions
1) When the battery voltage is too low, the battery symbol " " is displayed, please
charge it in time.
2) Low battery voltage affects measurement accuracy
3) When the boot screen flashes, the screen goes black. It may be that the battery power is
not enough to boot. Please charge it fully before starting measurement.
4) The battery symbol " " flashes to indicate that it is about to be shut down, and the
test cannot be performed at this time. Please fully charge the battery and start the test
again.
XI. Mobile APP Instructions
1) After installing the APP of "Ground pile clamp earth resistance tester. apk" in the CD, open
the APP to search for a Bluetooth device named "CLAMP_METER" (This function can
only be used for devices with Bluetooth), click it and wait for successful connection
(Bluetooth PIN code: 123456 is required for the first connection).
2) If the mobile phone is connected to the instrument through Bluetooth, the software on the
Alarm type
Alarm State
Alarm threshold
Threshold step cursor