HT 400 Series, User Manual

Page: 56 / 88

400 Series
EN - 54
6.8.1. AIR, RH, TMP °F, TMP °C, Lux mode
3. Insert the connector of the probe being used into the instrument input In1 making sure
that the probe connected and the set measurement unit correspond
4. Press the
GO/STOP
key. The instrument stops
updating the measured value and
STOP
appears on the right bottom part of the display.
Press the same key again to restart the
measurement and the real-time display of the
instant value of the input parameter. In this
case,
RUN
appears on the right bottom part of
the display.
A U X
I n 1 = 7 . 0 8 L u x
Lux LX 20
STOP
Func FS
5.
Measures can be saved, both in RUN and in STOP mode, by pressing the
SAVE
key twice or the
SAVE
key and, subsequently, the
ENTER
key (§ 8.1)
6.8.2. Description of anomalous results
1. In AIR, RH, TMP °F, TMP
°C, Lux or VOLT mode, if the
instrument measures an
input value higher than the
full scale, it displays a screen
similar to the one reported
here to the side. Check that
the full scale selected on the
instrument matches the full
scale on the transducer
A U X
I n 1 > 2 0 . 0 0 k L u x
Measured value higher than the
instrument’s full scale
Lux Lx 20k
Func FS
2.
The results displayed can be saved by pressing the
SAVE
key twice or the
SAVE
key and, subsequently, the
ENTER
key (§ 8.1)
3. The previous anomalous result cannot be saved