HST Addressable fire alarm MN-300, Operating Instructions Manual

Page: 9 / 26

Page 7

Air in fan

Air valve

Air out fan

Air out valve

Valve

Electromagnetic Valve

Agent

Water flow displayer

Hydrant

Pressure

Temperature sensing cable

Manual call point

IO module

Combined

Infrared

Heat

Photoelectric

Ion
Note: The types of equipment is shortening in display, please see attached list 1 for their
corresponding relationship.
Production type: This refers to the production types of detectors. The user may set these through auto
login or manually through
▲
and
▼
. The following types are available for selection by the user.

Hydrant call point

Manual call point

Combined detector

Heat detector

Photoelectric smoke detector

Ion detector

Beacon

Horn

Horn/Strobe

Fireman control module

Bus manual control module

Monitor and control module

Control module

Monitor module

I/O Module
Note: The types of production is shortening in display, please see attached list 2 for their
corresponding relationship.
Output mode: This refers to the output mode of the control module during a linkage output. It may be
selected through
▲
and
▼
. The following output models are available for selection by the user.

Constant output: This means a module keeps outputting after it starts to operate until the control
panel is reset or gives a stop instruction.

Pulse output: This means a module automatically stops outputting in 6 seconds later after it starts to
operate.
Operating mode: This is used for setting the sensitivity of a detector through
▲
and
▼
. There are three
sensitivities available as follows for selection by the user.

Medium sensitivity

Low sensitivity

High sensitivity
Position: This is the description of the specific position of a piece of equipment. It may be used for
describing the specific positions of various equipment addresses. At most 7 Chinese characters or 14
letters may be inputted.