HST Addressable fire alarm MN-300, Operating Instructions Manual, Page: 6 / 26

Page 4
Press
▲ ▼ ◀
or
▶
to move the cursor to the wanted function, and then press the # key to enter or the
* key to go back. If no selection is made within three minutes, the system will exit the main menu, return
to the main interface and lock the panel keyboard.
§2-2 System setup
Enter the System interface, and the following content will be seen.
Press
▲
or
▼
to move the cursor, press the # key to set the option where the cursor is and the * key to
go back. For example, if the cursor is now at the Time Setup option, pressing the # key can change the
current time.
§2-2-1 Time setup
Select Time setup in the menu, and the interface will display the following content.
What is displayed in the top right corner is the current time. Press
◀ ▶
to move the cursor to the
option to be changed, input the wanted figure and press the # key to confirm the change or the * key to
cancel the change and maintain the current time.
§2-2-2 Repeater panel setup
Select Repeater panel setup in the menu, and the interface will display the following content.
Select No., Register, Zone, Floor, Type or Indicate by pressing
◀ ▶
. Type and Indicate are two
constant options. At present, only CFT-982 Chinese display panels are equipped with the system for use
by the user.
When the cursor is at the Display option, the user can change the display mode by pressing
▲
or
▼.

By Zone: Display all the alarm information for the entire zone.

By Floor: Display the fire alarm information of the floor or the floors close to it.
Note: According to the requirements of relevant national standards, when the “By Floor” mode is
set for the display panels and the Floor No. is 1, all the fire alarms from the basements will be
displayed.
The system can be connected to 30 display panels at most. If there are lots of display panels or the
connecting lines are long, it is suggested to use thicker twisted-pairs when possible. For usage at a
place with strong interference, it is suggested to use shielded twisted pairs (STPs) and welding
technology for the joints when possible. The detailed wire diameter depends on the construction