38
2.991.999.120_en
07/2013
SP 5088
–
Press the start button
•
The cutting unit and feed belt start up
–
Place the material to be shredded on the loading table and then place batches on
the infeed conveyor
If material that is not supposed to be shredded is mistakenly placed onto the conveyor
belt do not try to pull it out, but
–
Press the start button again
•
The cutting unit and feed belt stop
–
Press the R-button
•
The cutting block and feed belt run in reverse
–
When you release the R button, the shredder will be stop
–
You can now remove the material from the belt and start the shredder again by
pressing the start button
Note
Provided the cutting unit is running in the shredding direction, you can
stop it by pressing the R button.
The shredded material falls through the discharge chute of the shredder directly into the
hopper of the press.
The press cycle is initiated by the light barrier inside the hopper when a certain fi lling
level is reached. The press ram moves forwards and compresses the material. The
press ram automatically returns to its rear end position after expiry of the pressing time.
The shredder continues running during the press cycle.
–
Feed the paper shredder with material until the wooden frame is ejected at the end
of the press channel during the compression process
–
Switch off the main switch on the baling press
–
Draw in the 3 strapping tapes (as described in section 4.5)