6
Powerline FA 400.2
08/2013
FA 400.2
• The transport device (e.g. hand pallet truck) must be
correspondingly rated for the weight of the machine
(425 kg).
• During transport, observe the high centre of gravity of
the paper shredder!
• Place the shredder in its packaging on a smooth, level
surface.
• Observe the instructions for unpacking.
• Remove the packaging.
• If you need to move the shredder through narrow
doors, you can wait until it is at its fi nal location before
fi tting the loading tray. Without the tray, the machine is
only 805 mm wide.
• The shredder may only be placed in dry rooms on a
hard, level fl oor – not on carpets. The fl oor load on
each roller is approximately 107 kg.
• Place the machine in such a way that the power plug
is easily accessible and the ventilation slots are free.
Make sure the power cable is unobstructed and that
nobody can tread on it.
• The shredder can be moved on its rollers.
If using a forklift to transport a Solo machine, you
must fi rst remove the waste trolley. Then you can
push the forks under the machine from the left or right
side and lift it up.
•
Solo machine:
- Lock the front castors by pressing down the brake
lever.
- Connect the power plug of the shredder to the 32A
CEE mains socket.
•
Combination version:
- Push the shredder up to the baling press until the
press and the outlet chute of the shredder touch.
- Bolt the shredder and the baling press together.
- Lock the front castors by pressing down the brake
lever.
- Connect the power plug of the shredder to the com-
bination socket of the baling press.
• The machine must be connected to a power source
which meets the specifi cations on the nameplate.
Fitting the loading tray:
Fasten the tray on both sides at the top with the Phillips
screws (1) and at the bottom with the 2 nuts (2).
1
2
Attaching the waste bag (Solo version)
• Open the front door and pull out the waste trolley.
• You can modify the trolley from a double-chamber to a
single-chamber system by removing the brackets (1).
1
• Put in a new waste bag and fold it approximately
20 cm over the top frame tube. When using a two-
chamber system, make sure that there is also around
20 cm of plastic foil below the brackets (1).
• Push in the waste trolley and close the front door.
5 Transportation,
installation
http://www.monomachines.com/
http://www.monomachines.com/
