10
Powerline FA 400.2
08/2013
FA 400.2
Note:
Do not tighten the chain too much, as this will cause pre-
mature wear on the chain and bearings.
Cleaning the cutting block
Strip cut machines: (1 x daily)
• Switch off the shredder.
• Squirt special cutting apparatus oil through
the paper feed opening onto the blade roll-
ers.
Order no. 1.235.997.403 for a 250 ml bottle
Order no. 1.235.997.501 for 5 litre con-
tainer
• Let the cutting apparatus run forwards and
backwards several times without feeding
in any paper.
This loosens paper dust and particles.
Cross cut machines:
If the cutting quality de-
teriorates or the machine
becomes noisy:
• Let the shredder run without
feeding in any paper.
• Push the lever of the oiler
down several times.
• Make sure the oil level in
the container is between the
MIN and MAX markings.
Order no. 1.235.997.501 for
5 litre container
If you need to tighten the
chain:
• Remove the right cover
panel.
• Loosen the nuts and
push the motor and the
tensioning screws until
the chain sags by
4 – 10 mm.
• Tighten the nuts again.
• Put the cover panels and
the tray back on.
The sag of the chain
should be 4 – 10 mm.
Checking the chain tension (twice yearly)
• Switch off the shredder.
• Pull out the power plug.
• Remove the tray and the left cover panel.
MIN
MAX
9 Maintenance and care
WARNING
Service work may only be carried out by
HSM Customer Service or by the service
technicians of our contractual partners.
http://www.monomachines.com/
http://www.monomachines.com/
