08/2013
Powerline FA 400.2
11
FA 400.2
Greasing the drive chains and cogs (twice
yearly)
• Switch off the shredder.
• Pull out the power plug.
• Remove the tray and the cover panels.
• Grease the cogs and the drive chains from
the motor to the cutting apparatus, the cut-
ting block to the feed belt and the cutting
block to the regulating roller.
Recommended lubricating grease: K2K in
accordance with DIN 51502/DIN 51825
• Put the side cover panels and the tray
back on.
Tightening the feed belt
The feed belt should not slip when loaded with material.
• Switch off the shredder.
• Loosen the hex nuts
(1) on the left and
right sides of the
snub roller.
• Loosen the lock nuts
(2) of the tensioning
bolts (3).
• Tighten the feed belt
evenly
using the
tensioning bolts.
Note:
Only tighten the feed belt until it stops slipping. The feed
belt bearing may be damaged if it is tightened too much.
• Tighten the hex nuts on the snub roller and
the lock nuts on the tensioning bolts again.
1
1
2
3
2
3
You must check that the feed belt runs
straight:
Switch on the shredder and let it run for
10 minutes. During this time, the feed belt
must run in the middle of the snub roller. If it
slips to the left or right edge, you must alter
the setting of the snub roller.
Checking the feed belt for wear
The surface of the feed belt can become worn after long
periods of use. If you can see the fabric inlay in the belt, it
must be replaced. Please notify our customer service.
Cleaning the shredder:
• Switch off the shredder and disconnect the power
plug.
• Only use a soft cloth and mild soapy water for
cleaning. Never use scouring agent, cleaning fl uid,
petroleum or thinners.
•
Machine on pallet with a wooden frame, strapped with
packing tape and packed in foil
• 4 waste bags, order no. 1.513.995.000 for 2-chamber
system (Solo version)
• 1 waste bag, order no. 1.513.995.100 for 1-chamber
system (Solo version)
• Special cutting block oil
For strip cut machines: 250 ml bottle, order no.
1.235.997.403
For cross cut machines: 5 l container with spout, order
no. 1.235.997.501
• Operating
manual
• Accessories: strip curtain, order no. 1.513.050.445
Dispose of the machine in an environmentally sound
way at the end of its service life. Observe the current
regulations when doing this. As legislation is subject to
ongoing changes, we request that you contact your local
authorities at the appropriate time. As the manufacturer,
HSM would be glad to advise you on the disposal of your
old machine.
10 Disposal / Recycling
11 Scope of supply, accessories
http://www.monomachines.com/
http://www.monomachines.com/
