If building a Double Wide Stand, place the Center Rail on top of the Primary
Supports with the threaded inserts pointing toward the bottom of the stand. (See
Picture 7.)
Picture 7
As in Step 1. Use two of the
¼
”-20x 1” button head fastener with a
¼
” flat
washer on each of the fasteners and place one of them through the Primary
Support. Carefully move the Side Rail or Center Rail so that the top of the rail
and the support are level with each other. The fastener should easily thread into
the Rail. Again do not fully torque any of the fasteners yet. Place two fasteners in
each Primary Support (see picture 2) diagonally across from each other.
Additionally when building a Double Wide Stand, it is best to turn the first half of
the stand onto its back or front, and then add more Primary Supports, Side or
Center Rails as needed. It is important to keep the orientation of the front of the
Primary Supports in mind while assembling the stand. All the sides with the two
grooves should face the same direction in the stand. (See Picture 8.)
