VDP1500ASM_v2
HQPOWER
4
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5. Use
a.
Description
1.
DIP switches
2.
DMX input
3.
DMX output
4.
wireless controller (not incl.)
5.
input for wired controller (incl.)
6.
output from wired controller
7.
power supply input connector and fuse holder
8.
on/off switch
b.
Adjusting the Output Angle
•
Unscrew and remove both knobs.
•
Set to the desired angle.
•
Fix the angle by screwing both knobs back into the smoke
machine.
c.
LEDs
•
Red LED: Device is heating.
•
Green LED: Device is ready for use.
d.
Turbo Function
This function can be useful when you need a more intense smoke output in e.g. cold rooms (smoke liquid will
be affected by a cold environment) or when the smoke liquid is diluted.
Summary of Contents for VDP1500ASM
Page 2: ...VDP1500ASM_v2 HQPOWER 2...
