HPI Racing reactor 500, Instruction Manual

Page: 29 / 134

27
For your convenience the Reactor 500 has the ability to store and load your program data. It can
store up to 5 sets of battery data. You can recall this data when charging or discharging without the
need to set up the program again.
PROGRAM SELECT
SAVE DATA
START
ENTER
NiMH CHARGE Aut
CUR LIMIT
5.0A
NiMH DISCHARGE
1.0A
11.0v
Pressing START/ENTER will then allow you to cycle through your saved
data. “INC” or “DEC” will select the next saved battery. Pressing the
START/ENTER key will select that data. The example is a NiMH battery
which has 12 cells and a capacity of 3000mAh.
Once selected the charge current can be altered, or the current limit in
“AUTO” mode. Press “INC and ”DEC” simultaneously to make the current
field blink to switch the charge mode.
In “DISCHARGE” mode you can set up the discharge current and final
voltage
DEC INC
DEC INC
DEC INC
Data Storage Program
SAVE [01] NiMH
14.4V 3000mAh
*
Data
Number
Type of
Battery
Voltage Capacity
DEC INC
*
DEC INC
START
ENTER
>3 Seconds
BATT
STOP
BATT
STOP