• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1.
2.
Remove the system board module from the chassis.
3.
Place the system board module on a flat, level work surface.
4.
Remove the system board module access panel.
5.
Remove the primary PCIe riser cage.
6.
Remove the OCP NIC 3.0 adapter blank.
7.
Some servers provide a locking latch. Lift the locking latch, and then slide the OCP NIC 3.0 adapter through the rear
of the chassis. Align and install the OCP NIC 3.0 adapter into the slot. Press firmly to fully seat the adapter into the
connector. Rotate the latch to lock the adapter in place.
Hardware options installation
76
