HPE ProLiant m710x, User And Maintenance Manual

Page: 19 / 58

Powering up the chassis
If the chassis was powered off while installing the cartridge, then power up the chassis. The cartridges are
hot-pluggable and do not require that you power down the chassis for the installation.
Procedure
1. Connect the power cables to the power supplies.
2. Connect the power cables to the power source (UPS or wall outlet) or to an installed PDU.
3. Wait while the chassis powers on. Verify the status of the power LED on the front panel of the chassis.
For more information on the chassis power LEDs, see the
HPE Moonshot 1500 Chassis Setup and
Installation Guide in the Hewlett Packard Enterprise Information Library ( http://www.hpe.com/info/
moonshot/docs ).
Powering up the node
Upon installation into the chassis, auxiliary power is provided to the cartridge. Depending on chassis
autopower state, nodes may power up automatically upon cartridge installation.
Procedure
1. Log in to the iLO CM firmware on page 17.
2. Show the installed cartridges to determine node status:
hpiLO -> show node list
3. Power up the preferred node:
hpiLO -> set node power on C<x>N<y>
For more information on configuring the cartridge, see the following documents in the Hewlett Packard
Enterprise Information Library (
http://www.hpe.com/info/moonshot/docs ):
• HPE Moonshot System Configuration and Compatibility Guide
• HPE Moonshot iLO Chassis Management CLI User Guide
Updating cartridge firmware
The minimum supported iLO CM firmware version for use with this cartridge is iLO Chassis Manager
Firmware version 1.31.
IMPORTANT:
To ensure that the latest firmware version is loaded correctly, power down the cartridge node before
updating the cartridge firmware.
A system ROM flash does not take effect on a node until the node is rebooted. The iLO CM firmware will
reflect the system ROM flash immediately.
Procedure
1. Verify the firmware version by entering one of the following commands:
•
show firmware revisions all
•
show firmware revisions list
2. Download the latest firmware version from the HPE Moonshot Component Pack download site ( http://
www.hpe.com/info/moonshot/download ).
For more information on updating the firmware, see the HPE Moonshot iLO Chassis Management CLI
User Guide in theHewlett Packard Enterprise Information Library ( http://www.hpe.com/info/moonshot/
docs ).
Powering up the chassis 19