on page 23.
on page 42.
on page 21.
Installing the M.2 SSDs
Prerequisites
A No. 1 Phillips screwdriver is required to perform this procedure.
Procedure
1.
on page 21.
2.
on page 22.
3.
Place the server blade on a flat, level work surface.
4.
on page 22.
5.
Remove the left DIMM baffle (
on page 23).
6.
Verify that the PEM nuts and rubber stoppers are in the correct location to support the length of the
M.2 SSDs being installed. Relocate the PEM nuts and rubber stoppers, if necessary.
Relocate the PEM nut and rubber stopper
on page 28.
7.
Remove the screw with a No. 1 Phillips screwdriver, and then install the M.2 SSD.
Hardware options installation
59
