32
Removing an interface module
CAUTION:
•
Before you remove an interface module, remove the cables from it to avoid cable damage.
•
If you are not to install a new interface module after removing the original one, install the filler
panel in the slot to prevent dust and ensure good ventilation in the device.
To remove an interface module:
1.
Prepare an anti-static bag.
2.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
grounded.
3.
Press the latch to release the ejector lever.
4.
Rotate outward the ejector lever as shown by callout 1 in
.
5.
Pull out the interface module slowly out of the interface module slot, as shown by callout 2
in
6.
Place the removed interface module in the anti-static bag.
Figure 42 Removing an LSWM18QC interface module
Verifying the installation
After you complete the installation, verify that:
•
There is enough space for heat dissipation around the switch, and the rack is stable.
•
The grounding cable is securely connected.
•
The correct power source is used.
•
The power cords are correctly connected.
•
All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket
strip with lightning protection and lightning arresters for network ports have been correctly
connected.
