HPC 49X8SSEI-L, Installation & Operation Instructions

Page: 10 / 23

10
4/28/2017 860-EI
EI FIRE PIT SHUTDOWN
1. Tu rn “OFF” fire pit using remote or wall switch.
IMPORTANT: FOR REMOTE CONTROL USE, YOU MUST ALSO TURN OFF POWER TO
ELECTRICAL OUTLET OR GAS TO FIRE PIT TO PREVENT ACCIDENTAL START.
2. Once fire pit is cooled, use appropriate cover to protect fire pit.
B.
HIGH / LOW MODELS- HPC Remote Control
, after turning ON gas to fire pit operate as follows:
1.
Remote Sync
– The remote should arrive already sync’d to the fire pit.
a. To sync the remote to a fire pit:
1. Ensure power is off to fire pit.
2. Depress the low and off button simultaneously and hold until the remote flashes rapidly (8 to 10
seconds)
3. Release the low and off buttons
4. Apply power to the fire pit within 10 seconds – Fire pit will accept a new remote for the first 2
minutes it is on.
5. Allow the remote to finish flashing which could take up to 30 seconds
6. Your remote should operate the fire pit
7. NOTE: If Steps 5 or 6 fail, please repeat Steps 1 ~ 7. Also confirm antenna placement- see Pg. 6
2. Normal Remote Operation LED
- for flash count
a. Power On/Off – 2 Flash
High
b. High – 4 Flash
Power On / Off
c. Low – 3 Flash
Low
d. Poor Communication - 10 Flash (Move closer or change positions.)
e. Remote Response Time – When not in use for more than 30 seconds the remote will go into a sleep
mode to save battery life. If remote is in sleep mode it may take a few extra seconds for a command to
be executed.
3.
Remote Range
– The remote should operate within a 20 foot distance from your fire pit reliably. Further
distances may be achieved depending on your particular application. Antenna extension cable is available when
needed.
a. Metal objects negatively affect communication between the remote device and your fire pit. Things
such as metal enclosures, metal grates and metal mesh for stone veneer or in some cases metal
furniture may interfere with communication between your remote device and the fire pit.
4.
For lost remote
– If the remote is misplaced, the fire pit may still be turned on by the following method.
a. Apply power for 5 seconds; turn off for at least 5 seconds. (Repeat 3 times- all times +/- 1 second).
b. Next time unit is powered up it will turn ON. Fire pit can still be turned off with the remote. Once
power is removed start over with Step a.
IMPORTANT
: If power to the fire pit is turned “Off” then immediately turned back “On” the system will go into
lockout mode. To reset, turn off, wait 5 minutes, then turn on.
C. HIGH / LOW MODELS- Smartphone Control
, after turning ON gas to fire pit operate as follows:
(Also see hpcfire.com for more information)