HP ZBook 14 G2 Mobile Workstation, Maintenance And Service Manual

Page: 92 / 144

TouchPad
NOTE: The TouchPad spare part kit includes the TouchPad cable.
Description Spare part number
For use only on HP EliteBook 840 G2 Notebook PC and HP EliteBook 740 G2 Notebook PC
computer models equipped with an NFC module (includes NFC module cable) 799301-001
For use only on HP EliteBook 840 G2 Notebook PC and HP EliteBook 740 G2 Notebook PC
computer models not equipped with an NFC module 797437-001
For use only on HP ZBook 14 G2 Mobile Workstation computer models equipped with an NFC module
(includes NFC module cable) 798048-001
For use only on HP ZBook 14 G2 Mobile Workstation computer models not equipped with an NFC module 797438-001
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see Service cover on page 51 ), and then remove the following components:
a. Battery (see Battery on page 53 )
b. Keyboard (see Keyboard on page 63 )
c. Base enclosure (see Base enclosure on page 75 )
d. NFC module (see NFC module on page 79 )
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the card reader board.
2. Remove the two Phillips PM2.0×2.0 broad head screws (2) that secure the TouchPad to the top cover.
3. Lift the top edge of the TouchPad until it rests at an angle (3).
82 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts ENWW